Static

This analysis type is used to determine the displacements and stresses in structures or components caused by the applied constraints and steady loads - inertia and damping effects are ignored. A Static analysis can be either linear or nonlinear. | Page 47

Template for the convergence study course in Coursera - Copy

a dynamic test stand to test bicycle drivetrains

Praktikum di Minggu 3:
Dari percobaan jobsheet di minggu ke-2 rubah luas penampang nya menjadi 8 x 12.5
(satuan inch) dengan menggunakan parameter konfigurasi sebagai berikut :
- Luas Penampang = 8 x 12.5 inch
- Tinggi = 10 inch
- Material = Alumunium
- Boundary Conditions :
Fixed Support = Permukaan Atas
Force = Permukaan Bawah (Fz = +950.000 Newton)
- Meshing = Sizing Automatic, Fineness = 2, 5 dan 10
Cari nilai displacement baik secara software dan validasi perhitungan manual !
bandingkan hasilnya apabila meshing fineness = 2, meshing fineness = 5, dan meshing
fineness = 10

Engine bearing analysis of an airplane - Copy

This is my second ever stress simulation, specifically a linear static stress analysis for a part of my tvc rocket project

It is a mesh convergence study using SIMSCALE

This project demonstrates the static stress analysis of three aircraft engine bearing bracket models considering both linear and nonlinear material definition. The models are tested with horizontal and vertical loading conditions as provided on the challenge page of GrabCAD. - Copy