Static

This analysis type is used to determine the displacements and stresses in structures or components caused by the applied constraints and steady loads - inertia and damping effects are ignored. A Static analysis can be either linear or nonlinear. | Page 202

Strength test for a 3d printed alto saxophone lyre

Used for the Done in 60 Seconds Webinar with Onshape.

It is  a coursera  tutorial - Copy - Copy

Validation Case for the Coursera course on engineering simulation.

In this project a static analysis of an I-beam under remote force is demonstrated.

Status: Public. - Copy

Tutorial project for a stress analysis of a connecting rod. The project only provides the geometry to start with. See our tutorials section to have a look at the step-by-step instructions to set up the simulation. - Copy

Trying to determine whether rubber/isolator will significantly change load

Tutorial project for a stress analysis of a connecting rod. The project only provides the geometry to start with. See our tutorials section to have a look at the step-by-step instructions to set up the simulation. - Copy - Copy

This project demonstrates the static stress analysis of three aircraft engine bearing bracket models considering both linear and nonlinear material definition. The models are tested with horizontal and vertical loading conditions as provided on the challenge page of GrabCAD. - Copy