Static

This analysis type is used to determine the displacements and stresses in structures or components caused by the applied constraints and steady loads - inertia and damping effects are ignored. A Static analysis can be either linear or nonlinear. | Page 189

Template for the lecture held at the Karlsruhe Insitute of Technology for the workshop in mechanical design IV (Summer Semester 2019) - Copy

Validation Case for the Coursera course on engineering simulation.

In this project a static analysis of an I-beam under remote force is demonstrated.

Status: Public. - Copy

This project demonstrates the static stress analysis of three aircraft engine bearing bracket models considering both linear and nonlinear material definition. The models are tested with horizontal and vertical loading conditions as provided on the challenge page of GrabCAD. - Copy

analysis of variable circular cross section of cantilever beam

Template for the convergence study course in Coursera - Copy

Engine bearing analysis of an airplane - Copy - Copy

Connecting Rod Subjected to 10kN force in tension

This is not the original version!!! - Copy

Checking the sealing fitting process on a quarter symmetry model with and without friction. This is a sample hyperelastic rubber material using the Mooney-Rivlin model. Results of interest are the required fitting force as well as the contact state and pressure.

Una barra de 0,25 in de diámetro y 4,8 ft de largo se somete a una carga de 750 lbf.

Assessing the failure that Claus experienced with this part