Static

This analysis type is used to determine the displacements and stresses in structures or components caused by the applied constraints and steady loads - inertia and damping effects are ignored. A Static analysis can be either linear or nonlinear. | Page 131

Template for the convergence study course in Coursera - Copy

Template for the convergence study course in Coursera - nithish

Connecting rod subjected to a 10kN force in tension

Tutorial project for a stress analysis of a connecting rod. The project only provides the geometry to start with. See our tutorials section to have a look at the step-by-step instructions to set up the simulation. - Copy

Evaluate Modes and Mode shapes for Shaft Supported by 2 Ball Bearings

Validation Case for the Coursera course on engineering simulation.

In this project a static analysis of an I-beam under remote force is demonstrated.

Status: Public. - Copy

Copy of the project Biegeversuch by @aniossa - Copy

Bracket to attach rear rack around disc brakes

This project demonstrates the static stress analysis of three aircraft engine bearing bracket models considering both linear and nonlinear material definition. The models are tested with horizontal and vertical loading conditions as provided on the challenge page of GrabCAD. - Copy

Trabalho final da disciplina de Engenharia da Manufatura

Tutorial project for linear static analysis of a crane