Static

This analysis type is used to determine the displacements and stresses in structures or components caused by the applied constraints and steady loads - inertia and damping effects are ignored. A Static analysis can be either linear or nonlinear. | Page 1

Stress analysis of varying geometries of GTM seals (pipe)

pump connector mount on steel plate surface , to verify and check the surface thickness is proper or safe.

Mech simulation of the slab - Copy - Copy

This project focuses on designing, analyzing, and testing a CubeSat for potential space missions. The CubeSat is a small, modular satellite that follows the 1U (10x10x10 cm) standard, designed for scientific research and technological experiments in low Earth orbit (LEO).

Compare stress in solid vs. lattice-structured implants.
Geometry:
•	Implant dimensions: 0.15 m × 0.02 m (diameter).
•	Lattice structure: Gyroid (50% porosity).
Material: Titanium (E = 110 GPa, ν = 0.33).
Boundary Conditions:
•	1 kN compressive load simulating body weight.
•	Fixed support at the distal end.
Analysis Steps (SimScale):
1.	Static structural analysis.
2.	Homogenize lattice properties (simplified model).
3.	Compare stress and weight reduction.
Deliverables:
•	Stress distribution in lattice vs. solid.
•	Weight reduction percentage.
Validation: Compare with experimental data on lattice compression.

Tutorial showing the workflow for nonlinear FEA structural analysis, including varying load, hyperelastic material and elastic support.

Evaluate forces and stresses of bender with different materials.

Prótesis ensamblada completa - TPU y PLA - Copy - Copy

STUDY THE STRESSES ON THE CURRENT SPINDLE DESIGN