Hello, let me start by saying that these are my first simulations on SimScale. I created a front wing in the cad editor then I setup everything , I meshed it and run the simulation. But in the post processing, I can’t see the pressure measure, I see only this. Can someone help me ?
Hi @Luca05, thanks for posting on the forum 
Welcome to the SimScale Community 
Always make sure to post your project’s URL when writing a forum post. I assume this is the one:
When it comes to the pressure, I can see the contour plots on my end - make sure to set the iterations to 1000 (1) and adjust the legend limits (2):
Best,
Igor
okay sorry, for not posting the link. Thanks