How to set up the transient simulation control in conjugate heat transfer

I am trying to set up a transient simulation by using conjugate heat transfer but the simulation control has become a big challenge because every data i entered in the simulation control can not bring the simulation to success. (N.B i have tried the steady-state simulation and it worked perfectly)

here is a link to my project

Hi!

Have you already checked this webinar on cost-efficient transient simulations, by any chance? That would be a good starting point.

Cheers

Hi, @RicardoParis
I have already watched the webinar but i can not properly set the time step because every time i try to simulate it says ‘maximum number of iteration exceeded’.