SimScale simulation projects by yabinghu | Page 1

yabinghu's profile

Tutorial project for a stress analysis of a connecting rod. The project only provides the geometry to start with. See our tutorials section to have a look at the step-by-step instructions to set up the simulation.

Axle shaft. In this project,  I build a model of a shaft. Inner shaft diameter 180mm, length 1200mm, outer diameter 150mm, length 200mm. Boundary Conditions: the inner shaft was fixed by two supports point at the ends.  Loads: on one end of outer shaft 1000000N in y-directions. Material: steel

plate with a hole.  Plate length 20mm, thick 1mm, and hole diameter 4mm.  Material properties: Young's Modulus, 210000000000 and Poisson's Ration, 0.3. Simulation 1 is loaded with 20MPa on 4 sides. Simulation 2 is loaded with 20MPa on left and right sides and up and bottom sides are fixed.

Tutorial project for a thermal analysis of a differential casing. The project only provides the geometry to start with. See our tutorials section to have a look at the step-by-step instructions to set up the simulation.

Load on a cantilever beam. I build a model of a cantilever beam by Onshape with 20m long, 2m height and 1m wild.  The material is steel. The boundary conditions: one end is fixed and the other end is loaded a 2000000N force in the y-direction. I made two meshes, one is fine and the other is coarse.

Public Profile

yabinghu's profile