SimScale simulation projects by wpcwork | Page 1

wpcwork's profile

Using existing geometry to try on the simulation

The goal is to investigate the behavior of an one-hour-design 3D printed glider while it gets actually printed.

116 minutes remaining before the wing sections are printed. Fin and fuselage still needs to be manufactured.
Hopefully some useful information will be acquired from this steady state incompressible CFD simulation before the hardware is all ready.
What is the speed range this plane can operate. Will this plane actually fly or it will be just a demo piece.

The glider is designed by some rules of thumb. 

Progress in the comments below! - Copy

Tutorial project for a flow analysis of a pipe junction. The project only provides the geometry to start with. See our tutorials section to have a look at the step-by-step instructions to set up the simulation.

Public Profile

wpcwork's profile