SimScale simulation projects by vrutkauskas | Page 1

vrutkauskas's profile

Simulation to show Conjugate flow through tube heat exchanger - Copy

to analyse the heat distribution on the DLA heater - Copy

Asses effectiveness of shell flow heat exchanger - Copy

Exhaust heat exchanger for small cogeneration unit - Copy

Thermal analysis and effect of a thin layer on the inner side of the tubes - Copy

U type Baffled Heat Exchanger
Analysis type: Conjugate Heat Transfer
Highlights:
1. Pressure Drop of the coolant
2. Outlet temperature of the Hot gas and coolant
3. Surface temperature of the Shell - Copy

This project demonstrates the flow of liquid water flowing through a heat-exchanger. The purpose of this simulation is to analyse the flow distribution and check if there are air locks created. - Copy

Test C
Design validation
Counter Flow - Copy

Test B
Design validation
Counter Flow - Copy

Coolingplate 4 model by use heat flux - Copy - Copy - Copy

We use the PLinth model of room for CFD Simulation - Copy

Coolingplate 4 model by use heat flux - Copy - Copy - Copy - Copy

This is a validation case of an insulated tube - Copy

heat transfer through sinusoidal wavy fins - Copy

To simulate the hot air flowing throw the heat exchanger and gaining the cold air at the other end. - Copy - Copy

Housing maximum temperatures - Copy - Copy

Pressure Drop at Different Flow Rates bt Coolant Plate Inlet / Outlet - Copy

izracunal bom laminarni to cez stopnico - Copy

Public Profile

vrutkauskas's profile