SimScale simulation projects by tti | Page 1

tti's profile

This project aims to showcase how to set up a harmonic analysis for an airfoil geometry. It is a continuation of the Frequency Analysis of an Airfoil (1/2) tutorial.

Drone propeller flow analysis simulation using MRF model and SimScale standard mesher.

This tutorial project aims to showcase how to set up and run a simulation for a pump geometry. The Standard meshing tool was used.

This advanced thermal management tutorial describes the setup and analysis of electronics cooling on an electronics box containing different electronic components being cooled by the airflow of a fan.

Tutorial project for a flow analysis of a pipe junction. The project only provides the geometry to start with. See our tutorials section to have a look at the step-by-step instructions to set up the simulation.

Conjugate heat transfer simulation tutorial.

Tutorial project for a stress analysis of a connecting rod. The project only provides the geometry to start with. See our tutorials section to have a look at the step-by-step instructions to set up the simulation.

Analyse the duct positioning to have effective ventilation system

This tutorial aims to showcase how to set up a compressible analysis. An aircraft wing geometry is used.

Empty project containing the geometry of an engine piston for the thermomechanical tutorial of an engine piston

Thermal Analysis of a Differential Casing

Public Profile

tti's profile