Looking for multiphase flow simulation templates? Sign up for SimScale and join the largest engineering simulation community in the world! | Page 1

Assessment of the water level of a cooling tower water distribution open channel.

The channel has a water inlet and numerous holes for outlet, while it is open to the atmosphere.

Three different designs are evaluated to optimize the filling performance. Watch our on-demand webinar about Multiphase capabilities where this case is presented in more detail
https://www.simscale.com/webinars-workshops/new-multiphase-flow-capabilities/

To decrease the sloshing effect with addition of baffle

To observe the sloshing effect with and without baffles

This part of the project on design and analysis of the spray drying system for drying of milk that we did in our final year of undergraduate studies in Mechanical Engineering at Kathmandu University, Dhulikhel, Nepal.

Quick assessment of the water level of a cooling tower water distribution open channel.
Multiphase flow. constant density, no energy equation.
The channel has a water inlet and numerous holes for outlet, while it is open to the atmosphere.

observe the flow field of a supersonic misty flow
CFD

Simulation of Ventilation behind submerged plate

The goal of the project was to demonstrate the hydraulic jump and find the height of the jump also compare simulation height with the calculated height. For this project, I used a multiphase simulation type (air and water).

This project is based at the Maritime Research Institute Netherlands (MARIN). Experiments have been performed for breaking dam flows. The main objective is to capture the water-air interface developed during the experiment in a 3.22x1x1 tank with free surface.

This project establish a comparison between 120mm and 130mm EBT valve.