Looking for hvac simulation templates? Sign up for SimScale and join the largest engineering simulation community in the world! | Page 14

Comparing supply terminal flow with and without an expanding cone

Incompresible, mesh 13-02-22, subterraneo 2,,HVAC

Observe the difference between ductwork design.

The project goal is to accurately simulate the cabin air by using a detailed diffuser geometry model from KSU and validate experimental available data.

This is a project to simulate the heat dissipation of a heat sink. A heat sink is a component that increases the heat dissipation of a device or an assembly.  A conjugate heat transfer simulation will be used to illustrate how heat flows away from the component. They are usually found in HVAC  systems, power plants and electronic appliances. The model was generated in CATIA v5.

Testing the duct placements to see if the salt fog will be effectively flushed from the room.

Demonstrate a simulation project for Thermal Comfort Analysis to a
new customer

Simple commercial kitchen ventilation with two exhaust hoods

Testing air flow in an office environment

Analyze temperature distribution and turbulence in the pathfinder container with diagonal ducting.

This project is to simulate and validate turbulence models. The goal here is to use LES to improve RANS. The generic cabin is available in the literature.

Study where to install AC unit in order to provide best air circulation and cooling effect.

1. Model airflow from low static pressure linear supply air plenum and diffuser

2. Objective to assess amount of leakage from plenum ends.