Looking for flow analysis simulation templates? Sign up for SimScale and join the largest engineering simulation community in the world! | Page 1

Does it flow? 

Made changes to model. Removed pins at the turn and put fins, removed some pins at the inlet and made also made inlet corners less round. 

This sim was set up with Pressure inlet + Pressure outlet. I was told that this 'boundary condition combination is very poor in terms of stability'. I don't think the data is any good? 

It is a fluid heat transfer block/water boiler block. The block goes onto heat source, water gets pumped into it, and aim is to heat up the water.

To increase the surface area there are lots of fins inside, and fluid needs to turn 180, so the fins at the turn are in a radial pattern.

I wanted to simulate the water flow to see what it might do, and see if there are any massive dead spots.

Francis Turbine CFD Analysis and optimzation

In this project I test out sphere's flow capability which will later help me design a spherical air mobile

In this project I'll be using air flow simulation which will help me to understand air dynamics of a particular model

From CFD to find the flow pattern thru large industrial fan and power requirement to rotate the same.

Projeto de Hidrodinamica Aplicada, I Simulacao de escoamento ao redor do casco de um navio .

this project for simulation of ventilation system

analyze the incompressible  flow in a converging duct

Investigation of laminar and turbulent flow in converging pipe

Aerodynamic part of options for me and my kit car build up planning

V2 plenum and runners to suit ford sigma/zetec se 1.6 and 1.7

Trying to see the flow of two columms in row. Distance between collums 7 metres, Reynolds number 1200. Dimensions 24X50

water flow in a convergent-divergent nozzle.

Conjugate heat transfer is a behavioural analysis where convective (transfer between fluid) and conductive (transfer between solids) heat transfer takes place in a system. This combination of heat transfer has forced or natural convection where fluid is dominated by convection and solid is dominated by conduction. 
Objective of the Experiment is to
Carry out mesh Independent study
Stimulate CHT using two different processor materials
Carry out the analysis at different velocities 
To determine the hot spots and Heat transfer co-efficient at different velocities

Analysis of flow patterns in a stirred tank using helical impeller with wall baffles

The rear wing plays a vital role to maintain the friction on the ground. The simulation analysis a flow over a rear wing developed to study the airflow patterns. An incompressible  external flow analysis is carried out to determine its flow patterns.

s1223rtl-il_58.33 percent thck (49 mm)_modified
559 mm chord
1770 mm span
close ground proximity

This project helps in studying the flow of fluid through the junction and internal flow of fluid.