Looking for cooling simulation templates? Sign up for SimScale and join the largest engineering simulation community in the world! | Page 1

Brak wentylacji, 134 diody (67 w symetrii) każda po 1W mocy. PCB ze zmienionym przewodnictwem ciepła.

Verification of the sufficiency of the cooling of the door plate

Simulation of the HVAC system in vertical farming. The goal is to maintain temperature at around 27 +- 2 degrees centigrade and relative humidity of less than 80%.

A 3D printer fan duct, simulated thanks to SimScale.

Thermal analysis of cooling system for solar panels

How air circulating around the room by using two ACs on strategic position

settinh the temperature, the water in evaporate place

Hotend cooling system for Micro Swiss direct drive extruder for Creality CR-10 / Ender 3 printers.

ender 5 pro partcoling for fanduct  with two fans

Inspired by this article https://insideevs.com/news/339220/tesla-model-3-battery-can-transfer-twice-the-heat-of-model-s-p100d/  this project goal is to evaluate the difference in cooling effectiveness between series and parallel cooling tube of an EV Battery Module.

The cooling strategies used to maintain the battery under 40C are cooling tubes places between the rows of cells. Inside the aluminium channel extrusions flows a coolant made of water and glycol.

This project goal is to determine  the narrowest ribbon that would provide enough cooling to the battery cells

To impart cooling to the electronic components

Jominy end quench test for steel. Hardenability

Goal is to make fan to cool electric motor while working with increased power
Aero simulation

find the heat flow inside an insulated container

Ender-5 Pro low noise cooling air duct for the motherboard.

Measuring the electric heat flow through the copper plates for the Carbon-PAEK sample

we are going to cool our engine with the fins.

Powertrain for hypothetical electric vehicle for cooling

cooling | SimScale Project Library | Page 1