Looking for conjugate heat transfer simulation templates? Sign up for SimScale and join the largest engineering simulation community in the world! | Page 1

Design a spiral heat exchanger to melt a solid at around -50C at the bottom of a vessel at -172C using CHT

conjugate heat transfer in a composite block

Demo of cooling of Raspberry Pi using the Immersed Boundary Method (IBM). 
IBM makes CAD cleanup and defeaturing obsolete. A CAD with detailed electronic features (pins, connectors, engravings, etc.) can be directly imported as is for simulation
In this demo a Raspberry Pi is overclocked and the heat transfer behaviour is compared for two cases where the fan is off and on.

Demonstration project of an electronics enclosure using CHT v2. Comparison different passive heat sink designs and comparison of active and passive cooling

Transient Conjugate Heat Transfer analysis of a turkey being fried in hot oil.

LED Spotlight project, aiming to bring the temperature of the diodes of an LED spotlight design below the maximum allowed temperature of the diodes of 90C. Comparison of different heat sink designs

natural convection cooling of a thermoelectric generator setup with heatplate including radiation

Thermal Simulation, Casted Heat Sink, Branch Design

This is a project to simulate the heat dissipation of a heat sink. A heat sink is a component that increases the heat dissipation of a device or an assembly.  A conjugate heat transfer simulation will be used to illustrate how heat flows away from the component. They are usually found in HVAC  systems, power plants and electronic appliances. The model was generated in CATIA v5.

Proviamo con il design a rombi nella disperazione

Ho cercato di ridurre le perdite di carico entro il limite da requisito in modo da avere un design più simile a quello finale/reale

Un canale solo nel mezzo un po piu grosso...Funzionerà

Canali ristretti per avere più turbolenza

Abbasso ancora per avere più turbolenza...

Alcuni piccoli aggiustamenti, verifica che funzionino nella speranza che migliorino!

Canali tutti con raccordi diversi ad hoc per stare sul centro delle TEC

Sezione ristretta con fresatura dall'alto