Looking for cfd simulation templates? Sign up for SimScale and join the largest engineering simulation community in the world! | Page 197

The aim of this project is to study the influence of rear wing support position.
In particular, in this CFD simulation a high side support rear wing will be studied.

There an odd effect of half pipe wing drag / lift related to flow speed. https://www.sciencemag.org/news/2016/11/how-fly-pipe. This can be used as a mechanical switch.

Evaluating Aerodynamic forces on a bluff body

In this exercise, you will work with the hex-parametric mesher to mesh a valve geometry. Check out www.simscale-academy.com for more classes on simulation.

In this project incompressible fluid flow simulation of a conical draft tube is carried out. The parameters data is collected from the course book on fluid dynamics and the validation of CFD simulation result with the theoretical result is also performed. Steady state incompressible fluid flow simulation is selected for the given case.
The draft tube is a pipe of gradually increasing area, which connects the outlet of the water turbine's runner to the tail race. Draft tube helps to convert the exit velocity head into pressure or potential head.

Calculate drag for a bluff body of the car design

Determination of Drag and lift of a formula student car

The goal of the project was to demonstrate the hydraulic jump and find the height of the jump also compare simulation height with the calculated height. For this project, I used a multiphase simulation type (air and water).

KFm3 Airfoil CFD Simulation for use on remote controlled aircraft.

CFD simulation of modified shape cybertruck

Structural Stability and Lift generation of a box wing

The aim of the project was to implement a porous media option and try to understand the basic concept behind through CFD setup. for this case, incompressible flow simulation type was used. In this case, the pressure drop across the two was calculated and done some iteration.

Achieve a good visualisation of flow around the car

Incompressible Tesla Pelton turbine Torque evaluation

Quasi-static aerodynamics for flapping wing UAV

Server rooms house sensitive hardware that can be damaged easily if exposed to extreme temperatures. So, the aim of this project is to find out the heat transfer in that room for material air. For heat transfer I did Conjugate Heat Transfer simulation analysis which tells us about the heat transfer between fluid air and the solid material of the server room.
So, from this project we can optimize the ventilation system design for server room in future planning.

The project goal was to find the best airflow around the operation theatre with a different Duct model.
so to achieve this goal, the duct was simulated with incompressible flow simulation type and then operation room was simulated with convection heat transfer simulation type.
At the end, The results of both duct design were compared and find the optimum duct design with respect to the operation room.

cfd | SimScale Project Library | Page 197