SimScale simulation projects by swit | Page 1

swit's profile

Learning about 8-Pin SOIC Thermal Structural Analysis

Steady State Heat Transfer on an LED PCB - Half

Learning about parametric heat sink design & simulation.

Learning how to do heat sink thermal test.

Calculate number of screws (min. distance between them) necessary to compress the automotive electronic gasket and ensure tightness between top and bottom housings for ip67 standards. Original project of @mydlikowskij

This project shows the thermal analysis of a LED with Insulated Metal Substrate - IMS - mounted on different heat sinks.

This project shows the transient thermal analysis of chips mounted on a printed circuit board (PCB).

In this project basics of conduction, convection and radiation are demonstrated.

Demo of cooling of Raspberry Pi using the Immersed Boundary Method (IBM). IBM makes CAD cleanup and defeaturing obsolete. A CAD with detailed electronic features (pins, connectors, engravings, etc.) can be directly imported as is for simulation In this demo a Raspberry Pi is overclocked and the heat transfer behaviour is compared for two cases where the fan is off and on.

Demonstration project of an electronics enclosure using CHT v2. Comparison different passive heat sink designs and comparison of active and passive cooling

LED Spotlight project, aiming to bring the temperature of the diodes of an LED spotlight design below the maximum allowed temperature of the diodes of 90C. Comparison of different heat sink designs

Tutorial project for a thermal analysis of a differential casing. The project only provides the geometry to start with. See our tutorials section to have a look at the step-by-step instructions to set up the simulation.

Public Profile

swit's profile