SimScale simulation projects by swarda | Page 1

swarda's profile

Tutorial project for a flow analysis of a pipe junction. The project only provides the geometry to start with. See our tutorials section to have a look at the step-by-step instructions to set up the simulation.

Tutorial project for a thermal analysis of a differential casing. The project only provides the geometry to start with. See our tutorials section to have a look at the step-by-step instructions to set up the simulation.

Tutorial project for heat transfer in an engine piston

Tutorial project for Aerodynamic simulation of compressible flow over Airfoil

Sample project for how to set-up the Hex-Dominant Parametric mesh for flow around a vehicle body.

The tutorial project is a sample Electronic cooling sink which consists of 3 solid regions and 1 fluid region. The solid regions are two FB-4 chips, which have a higher initial temperature and a heat sink over one of the chips. The air flows over the solid regions to remove the heat from it.

This  project analyzes the aerodynamics of a spoiler

Tutorial for Static stress analysis of Underrun protection device

Tutorial project for a stress analysis of a connecting rod. The project only provides the geometry to start with. See our tutorials section to have a look at the step-by-step instructions to set up the simulation.

Tutorial project for linear static analysis of a crane

Public Profile

swarda's profile