SimScale simulation projects by smatten | Page 1

smatten's profile

This tutorial project aims to showcase how to set up and run a simulation for a pump geometry. The Standard meshing tool was used.

This tutorial aims to showcase how to set up a compressible analysis. An aircraft wing geometry is used.

Zur Bestimmung der richtigen Netzeigenschaften

Tutorial project for a stress analysis of a connecting rod. The project only provides the geometry to start with. See our tutorials section to have a look at the step-by-step instructions to set up the simulation.

Tutorial project for a flow analysis of a pipe junction. The project only provides the geometry to start with. See our tutorials section to have a look at the step-by-step instructions to set up the simulation.

This project shows the bending of an Aluminium pipe through rolling process.

Tutorial project for linear static analysis of a crane

Tutorial on incompressible flow simulation for aerodynamics studies, using SimScale Standard mesh algorighm.

Drone propeller flow analysis simulation using MRF model and SimScale standard mesher.

Testrohr einzeln to try out the usual workflow

This project aims to showcase the different configuration options for the standard meshing tool, including basic and advanced settings. The various refinements are also covered.

Public Profile

smatten's profile