SimScale simulation projects by rszoeke | Page 1

rszoeke's profile

E Motor simulation Electromagnetics - Copy

computaional fluid dynamics - Copy - Copy - Copy

A structural analysis tutorial that focuses on the impact of forces acting on a fixed bracket. - Copy

Heat transfer analysis of a 3U Cubsesat.
We want to obtain the results of the temperature distribution in a transient state of a satellite made of aluminum with surface heat rates as inputs (solar radiation, albedo, earth cover, ...).

Copy of the project Biegeversuch by @aniossa

Evaluation of valve spring stiffness on 3000 and 6000 RPM

Wind Comfort Analysis in a sample city partly on a hill.

In this project a structural and an eigenfrequency analysis of a front wing is demonstrated.

Nonlinear Analysis to asses the force necessary to crush an aluminum pipe

The project try to test how the wind affect the architecture

A sample project to show a possibility how to model pre-stress in a bolt.

In this project, a thermal shock analysis of a globe valve is performed.

Pedestrian Wind Comfort Analysis for assessing the wind speeds in areas meant for recreational use.

Project copied from chrstark: GrabCAD Bearing Bracket - A new bracket design 

In this project a nonlinear dynamic analysis of a valve spring is demonstrated.

A contact analysis of a consumer snap fit mechanism is analyzed in this project.

This project demonstrates a simple simulation of a hollow drawing manufacturing process.

Simple bolted connection contact analysis. Project copied from @potyka_csaba

Loudhailer vibration analysis frame enhancements

Copy of the project Acrylic lid v2 - Acrylid lids for Vacuum Chamber by @rs20
Fixed the initial run failure by adding an additional constrained point and also added a new sim with the advanced static analysis for comparison and highlighting the usage of the remote displacement constraint.

Structure for  steel cylinder which will support about 10 tons of lead

A casing of a mobile phone is tested when being dropped from 2 meters height.

Educational Project Example for using a remote displacement as a pin constraint

The stress distribution within an impeller is analyzed under vibration load due to bearing tolerances.

A snap-fit is analyzed using a dynamic stress simulation including physical contact between two parts.

CAD geometrie was taken from GrabCAD user rovi

Copy from user gurav_harsh. undercarriage assembly of excavator static structural analysis trial.

To investigate bending displacements of rectangular press plates.

Public Profile

rszoeke's profile