SimScale simulation projects by rgaonkar | Page 1

rgaonkar's profile

Dynamic analysis on the left diff mount based on endurence lap simulation

dynamic analysis on a 46 teeth sprocket based on endurance lap simulation data

dynamic analysis on the right differential mount based on data from endurance lap simulation

template for transient analysis of spool for reference

This project is the template for transient fea on a 46 tooth sprocket

Dynamic nonlinear analysis on the snap fit

Dynamic fea analysis on a spool based on the data obtained from endurance lap

Static structural analysis of left differential mount

Static load analysis of rear sprocket of 46 teeth

Static nonlinear analysis of a ring cross-section snap fit

A contact analysis of a consumer snap fit mechanism is analyzed in this project.

Its a static non linear analysis of a snap fit

Changed coordinate-system and used symmetry advantage

Static structural analysis of RVE of 3D printed part in on flat and upright orientation

Aerodynamic analysis(compressible) of 2nd iterations of BWB wing

its an exercise of Session 1 of CFD Master Class

trial simulation for external aero example model

Aerodynamic analysis on a fixed-wing aircraft.
Compressible fluid flow analysis is used.
To identify flow separation.

Static structural analysis on  a bicycle cranck

Static structural analysis of Right differential mount which has mounting for break caliper as well

flow analysis of an exhaust manifold with butterfly valve

Static structural analysis o Differential mount cla,p

To finalize restrictor design using steady state flow simulation

Public Profile