SimScale simulation projects by paulosantos | Page 1

paulosantos's profile

The objective of this project is to analyze the thermal comfort in a kitchen.

Computation of the thermal comfort including Local Mean Age of Air and radiation in a meeting room using CFD simulation.

Validation of a journal paper on Experimental and numerical investigation of micro-environmental conditions in public transportation buses by S. Zhu et. al (2010)

The objective of this study is to analyse the drag behaviour on a sphere.

In this project, thermal stress analysis of polymeric photo-thermal microactuator was performed considering different bending angles and arm widths.

Drone propeller flow analysis simulation using MRF model and SimScale standard mesher.

The objective of this project is to carry out a study on mechanical stresses in a hydraulic hoist.

Stress Concentration vs Stress Singularity

Tutorial project for setting up a Multi-phase flow simulation

Tutorial project for a flow analysis of a pipe junction. The project only provides the geometry to start with. See our tutorials section to have a look at the step-by-step instructions to set up the simulation.

In this project vibration analysis of jet engine is performed.

This project involves the simulation of stress analysis of an aircraft wing. There are total 6 comparison configurations with 3 different models and two different load definition.

This project shows how to simulate the airflow inside an office space.

This project simulates air flow around an Aircraft at low sub-sonic compressible flow regime.

The objective of this project was to calculate the pressure drop across a ball valve using the CFD method. For this, three simulation scenarios were created: fully open valve (0 degrees), partially closed valve in 40 degrees and partially closed valve in 70 degrees.

Convective Heat Transfer
Radiation
Thermal Comfort
CFD

Public Profile

paulosantos's profile