SimScale simulation projects by p2623735 | Page 1

p2623735's profile

This project is aimed at creating a parametric analysis of heat distribution within a 3D printer.

Frecuency and Harmonic analysis of a 3D printer's frame.

Investigating the behavior of drag and lift and determine the stall zone for two different front wing flap angles: 6 degrees (standard) and 18 degrees (high downforce) considering a constant inlet velocity of 20 m/s.

To investigate the effect of changing the rake angle of the car by lowering the nose or lowering the rear.

First session assigment. DIY 3D Printer Workshop Series

Tutorial project for a flow analysis of a pipe junction. The project only provides the geometry to start with. See our tutorials section to have a look at the step-by-step instructions to set up the simulation.

Public Profile

p2623735's profile