SimScale simulation projects by nmok | Page 1

nmok's profile

This project shows how to simulate the airflow around a motorbike.

Tutorial project for a flow analysis of a pipe junction. The project only provides the geometry to start with. See our tutorials section to have a look at the step-by-step instructions to set up the simulation.

Confirmation of XFLR5 results for a wing with 8AR, 0.6 taper ratio, and 0.35 average chord. Comparison of drag and lift results at 0 AOA with 20 m/s free stream velocity.

Trial 2 of the wing for the new UTX aircraft. Constrained to 2 meters span, each semi-span is split into two sections with different chord lengths and taper ratios to try and emulate an elliptical wing loading.

preliminary skin friction analysis of a straightwing NACA4415 airfoil with an AR of 7.

Public Profile

nmok's profile