SimScale simulation projects by mtisme | Page 1

mtisme's profile

I increased the mesh fineness to 8 to check for mesh independence

Conjugate heat transfer simulation tutorial.

This tutorial contains a thermal comfort project, which analyses the duct positioning inside a theater, in order to have an effective ventilation system.

Computation of the thermal comfort including Local Mean Age of Air and radiation in a meeting room using CFD simulation.

I am increasing the fineness of the mess to 8 and leaving all of the other variables as standard. I  am checking if the results are mesh independent. I will not change any other variables. The results of this run are Cut 1s Pavg  2.48e+5 Pa, Cut 2s Pavg  -2.365e+3 Pa, and the pressure residual was 0.0479. The results of the solution file unchanged are Cut 1s Pavg  2.556e+5 Pa, Cut 2s Pavg  1.083e+3 Pa, and the pressure residual was 0.0205. The flow behaviors were very similar between the runs.

Fluid Flow Through a Valve Tutorial. I recreated the open inner region by deleting the previous open inner region. This resulted in the names of the faces being different than the tutorial's finished file. The solution did not converge.

Fluid Flow Through a Valve Tutorial. This file uses the mesh of the Finished Project file included in the tutorial.

Fluid Flow Through a Valve Tutorial Try 2

LED Spotlight project, aiming a bring the temperature of the diodes of a LED spotlight design below the maximum allowed temperature of 100C. A Conjugate Heat Transfer v2.0 analysis is used.

https://www.simscale.com/projects/stadlerj/heat_exchanger_thermostructural_analysis/

Tutorial project for a flow analysis of a pipe junction. The project only provides the geometry to start with. See our tutorials section to have a look at the step-by-step instructions to set up the simulation.

Public Profile

mtisme's profile