SimScale simulation projects by mmagar | Page 1

mmagar's profile

Tutorial for meshing of valve geometry with Snappy Hex Mesh

Tutorial project to set up the Hex-dominant Parametric mesh for rotating geometries. This mesh can then be used for MRF and AMI simulations that incorporate rotation effects.

Tutorial project for a flow analysis of a pipe junction. The project only provides the geometry to start with. See our tutorials section to have a look at the step-by-step instructions to set up the simulation.

Sample project for how to set-up the Hex-Dominant Parametric mesh for flow around a vehicle body.

Tutorial project for setting up the mesh using Hex-dominant automatic for external flow.

Tutorial project for setting up the Automated Hex-dominant for internal flow for an angled pipe geometry.

This meshing tutorial shows how to setup the Tetrahedral automatic, Tetrahedral parametric and the Tetrahedral with local refinements for a structural analysis simulation.




This tutorial shows how to analyze the Heat transfer in a heat sink.

Tutorial project for heat transfer in an engine piston

Tutorial project for a thermal analysis of a differential casing. The project only provides the geometry to start with. See our tutorials section to have a look at the step-by-step instructions to set up the simulation.

Tutorial project for setting up a Multi-phase flow simulation

The tutorial project is a sample Electronic cooling sink which consists of 3 solid regions and 1 fluid region. The solid regions are two FB-4 chips, which have a higher initial temperature and a heat sink over one of the chips. The air flows over the solid regions to remove the heat from it.

Tutorial project with the goal of simulating the wave effects on a boat.

Tutorial project for Aerodynamic simulation of compressible flow over Airfoil

Tutorial for In-compressible Turbulent flow through a cyclone seperator

Incompressible turbulent airflow around a front wing

This  project analyzes the aerodynamics of a spoiler

Forced Convective Heat Transfer - Raspberry Pi

Tutorial for Static stress analysis of Underrun protection device

Tutorial project for linear static analysis of a crane

Tutorial project for a stress analysis of a connecting rod. The project only provides the geometry to start with. See our tutorials section to have a look at the step-by-step instructions to set up the simulation.

Public Profile

mmagar's profile