SimScale simulation projects by kazimciit | Page 1

kazimciit's profile

Tutorial project for a stress analysis of a connecting rod. The project only provides the geometry to start with. See our tutorials section to have a look at the step-by-step instructions to set up the simulation.

Sample project for how to set-up the Hex-Dominant Parametric mesh for flow around a vehicle body.

Tutorial project for linear static analysis of a crane

The tutorial project is a sample Electronic cooling sink which consists of 3 solid regions and 1 fluid region. The solid regions are two FB-4 chips, which have a higher initial temperature and a heat sink over one of the chips. The air flows over the solid regions to remove the heat from it.

Tutorial project for Aerodynamic simulation of compressible flow over Airfoil

Tutorial project for a thermal analysis of a differential casing. The project only provides the geometry to start with. See our tutorials section to have a look at the step-by-step instructions to set up the simulation.

This project contains everything you need to work on the first homework assignment of the drone workshop

I designed a new drone arm as part of the Simscale Drone Challenge. In this project I imported the arm, meshed it, and subjected it to a 2.25N lift load (not sure if the direction is correct...). I did not have any previous experience with Simscale and the study shows what I managed to in a couple of hours. There are a few other projects which could do with some analysis in the future, so I will be back for more!

Public Profile

kazimciit's profile