SimScale simulation projects by jrivas_henriqu | Page 1

jrivas_henriqu's profile

Homework of the Workshop: Aircraft Design Workshop - Session 1

FSAE workshop session 1-Front Wing Analysis homework tutorial project.
For Step-By-Step see: https://www.simscale.com/forum/t/step-by-step-tutorial-homework-of-session-1/52675

In this exercise, you will complete a laminar pipe flow analysis

In this exercise, you will use linear static analysis to analyze several configurations of an aircraft engine bracket under a vertical load.

Session 1 homework : setup a steady-state structural analysis of an aluminum front suspension upright and analyze the results for stress and deformation.

This project is the starting point for the homework for Session 1  of  the Baja SAE workshop. It enables the user to analyse the plastic deformation in an All Terrain  Vehicle (ATV)  Suspension .

FSAE-Workshop Session-2 Homework project for aerodynamics of complete Formula Student Race Car

FSAE-Workshop Session-3 Homework project for aerodynamics of full car

Homewrok Heat Transfer Analysis of a Cooloing

Tutorial project for setting up the mesh using Hex-dominant automatic for external flow.

Sample project for how to set-up the Hex-Dominant Parametric mesh for flow around a vehicle body.

This is the Homeworkof the Aircraft Desing Workshop Session 2:  Bending of an Airfoil Frame Homework

FEA Master Class Session 3 handout: In this project the drop test of an iPhone 6 has been performed with and without case.

This is used as a starting point for the SimScale Users and participants of the Session  2 of the All-Terrain Vehicle Design Workshop

Incompressible Fluid Flow analysis of two globe valves

In this exercise, you will perform a simple heat transfer analysis on the SimScale Platform and then compare the results to a hand-calculated solution.

In this exercise, we will consider the deflection of a cantilever beam with a concentrated load at the free end. We can calculate the deflection by hand and via a static analysis using the SimScale platform.

Tutorial project for a stress analysis of a connecting rod. The project only provides the geometry to start with. See our tutorials section to have a look at the step-by-step instructions to set up the simulation.

Public Profile

jrivas_henriqu's profile