SimScale simulation projects by gned | Page 1

gned's profile

Tutorial project for a flow analysis of a pipe junction. The project only provides the geometry to start with. See our tutorials section to have a look at the step-by-step instructions to set up the simulation.

Tutorial project for a thermal analysis of a differential casing. The project only provides the geometry to start with. See our tutorials section to have a look at the step-by-step instructions to set up the simulation.

terna locale allineata con quella assoluta

Porous Media Test3, new set of parameters.

The effect of numerics on the simulation quality and convergence time.

This project involves the simulation of ventilation in an aircraft cabin. There are 6 comparison configurations with 3 different inlets and 2 outlets.

This project simulates air flow around an Aircraft at low sub-sonic compressible flow regime.

This project contains everything you need to work on your homework assignement

This project demonstrates a multiphase flow simulation of a waterfall.

In this project, steady state thermal analysis of a CFL light bulb is performed.

FSAE workshop session 1-Front Wing Analysis homework tutorial project.
For Step-By-Step see: https://www.simscale.com/forum/t/step-by-step-tutorial-homework-of-session-1/52675

FSAE-Workshop Session-4 Homework project for aerodynamics of complete Formula Student Race Car

FSAE-Workshop Session-2 Homework project for aerodynamics of complete Formula Student Race Car

Homework for the Sport workshop : Session 2 
CFD analysis of a  bike tyre

Handout project for the Sports Aerodynamics Workshop : Homework for Session 1 
(27th March 2017 )

FSAE-Workshop Session-3 Homework project for aerodynamics of full car

In this project basics of conduction, convection and radiation are demonstrated.

This project involves the simulation of stress analysis of an aircraft wing. There are total 6 comparison configurations with 3 different models and two different load definition.

This project includes everything you need to get started with the homework assignment of our makers workshop

Public Profile

gned's profile