SimScale simulation projects by ggiraldo | Page 1

ggiraldo's profile

This is a theoretical and practical tutorial introducing the concept and implementation of Remote Point Boundary Conditions, both for degrees of freedom restriction and load application. It features a number of illustrative simulations and a companion commentary post for all the explanation.

The objective of this project is to compare numerical results with the analytical theory of the pressure cone for bolted connections.

Step by step tutorial for the meshing, simulation and posprocessing of a structural analysis including plasticity. The case is the pressure burst of a gas tank.

Tutorial project for a flow analysis of a pipe junction. The project only provides the geometry to start with. See our tutorials section to have a look at the step-by-step instructions to set up the simulation.

Predict the resistance and trim angle of a planing hull.

To investigate bending displacements of rectangular press plates.

Burst pressure analysis of a steel 20 lb propane tank.

Finite Elements Analysis of the stress distribution and deformation of a road pavement section, including the top Hot Mixture  Asphalt and lower layers of different materials. The goal is to replicate results in a published paper, where the method is used to estimate HMA stiffness module from field measured stress and deformation values.

Step by step tutorial for the meshing, simulation and posprocessing of a structural analysis including plasticity. The case is the pressure burst of a gas tank. This is the project template to start from having just the geometry.

Pipe safety assessment against thermal load.

This is the project for homework 3 of the F1 Workshop.

This project simulates the natural convection in a kitchen

This project demonstrates the usage of rotating zones

Homework assignment project for the Air-Conditioning and Ventilation webinar session 2.

Tutorial project for a stress analysis of a connecting rod. The project only provides the geometry to start with. See our tutorials section to have a look at the step-by-step instructions to set up the simulation.

Structural analysis to check flexibility and strength of a CIK-FIA regulation compliant race kart chassis.

Lift and drag study around a NACA-0015 airfoil profile.

Drag and Lift calculation for a NACA-2412 airfoil profile.

This project contains resources for Session 1 of the F1 Workshop

Simulate aeodynamics of a F1 car. Based on the Perrinn F1 V2 model, wich is designed to comply with 2017 regulations.

This project shows how to simulate the airflow inside an office space.

In this project we are calculating the heat transfer and pressure drop across a bank of heated tubes. In addition, we are comparing our CFD calculated answer to a simplified engineering solution from Fundamentals of Heat and Mass Transfer by Incropera.

Analyzing stress in cylinder to hemispherical junction of  a pressure vessel.

Bolted connection simulation, for a typical flanged cover, as those encountered in API manhole nozzles. An axisymmetrical 3D model is employed to save on simulation time. Both linear and non-linear contact models are used for the bolted assembly.

its about bending of superconductor wrapped wire bending, it is for studying the mechanical properties of the super conductor tape.

Study die swell phenomena for extrusion process

FEA static and dynamic simulation analysis of a bike tubular frame

Bottom laser simulation. required for final result

Public Profile

ggiraldo's profile