SimScale simulation projects by gdas | Page 1

gdas's profile

This tutorial project aims to showcase how to set up and run a simulation for a pump geometry. The Standard meshing tool was used.

Project for Drone Workshop . Step-by-Step Tutorial: Homework of Session 1 - Level 2

Tutorial project for a stress analysis of a connecting rod. The project only provides the geometry to start with. See our tutorials section to have a look at the step-by-step instructions to set up the simulation.

This project simulates the natural convection in a kitchen

The effect of numerics on the simulation quality and convergence time.

The project illustrates how to simulate airflow around a complex F1 vehicle.

This project shows how to simulate the airflow inside an office space.

Tutorial project to set up the Hex-dominant Parametric mesh for rotating geometries. This mesh can then be used for MRF and AMI simulations that incorporate rotation effects.

Simulations comparing 2 variants of fans and the flows

This project simulates Discrete Phase Model for a monodisperse gas-solid fluidised bed

Tutorial project for a flow analysis of a pipe junction. The project only provides the geometry to start with. See our tutorials section to have a look at the step-by-step instructions to set up the simulation.

Tutorial project for a thermal analysis of a differential casing. The project only provides the geometry to start with. See our tutorials section to have a look at the step-by-step instructions to set up the simulation.

Public Profile

gdas's profile