SimScale simulation projects by dtito | Page 1

dtito's profile

Tutorial project for a stress analysis of a connecting rod. The project only provides the geometry to start with. See our tutorials section to have a look at the step-by-step instructions to set up the simulation.

The tutorial project is a sample Electronic cooling sink which consists of 3 solid regions and 1 fluid region. The solid regions are two FB-4 chips, which have a higher initial temperature and a heat sink over one of the chips. The air flows over the solid regions to remove the heat from it.

Tutorial for Static stress analysis of Underrun protection device

Tutorial project for linear static analysis of a crane

Tutorial project for a thermal analysis of a differential casing. The project only provides the geometry to start with. See our tutorials section to have a look at the step-by-step instructions to set up the simulation.

Tutorial for In-compressible Turbulent flow through a cyclone seperator

Tutorial project for heat transfer in an engine piston

Tutorial project with the goal of simulating the wave effects on a boat.

Public Profile

dtito's profile