SimScale simulation projects by dale_daly | Page 1

dale_daly's profile

Seeing if smaller holes allow for uniform heat flow

Using Model 2 in Heat Transfer simulation, assigning h-values, and including insulation

Use the bounding box in SimScale's CAD software instead of adding air in the Inventor assembly

LED Spotlight project, aiming a bring the temperature of the diodes of a LED spotlight design below the maximum allowed temperature of 100C. A Conjugate Heat Transfer v2.0 analysis is used.

First attempt at including air with Model 2

First attempt did not include the solid parts

Attempt 1 for Model 3 (has the heating element and heat sink separate to the aluminium bars)

Seeing what simulation options are available

Using the value of h I calculated by hand on 17-1-22 for the convection from the upper hot surface of the Head of the T-shaped hot metering block. I am aware this value does not represent the convection from all surfaces, however it is a first attempt and a rough approximation.

Model 2 - added holes for the thermocouples

Tutorial project for a thermal analysis of a differential casing. The project only provides the geometry to start with. See our tutorials section to have a look at the step-by-step instructions to set up the simulation.

Public Profile

dale_daly's profile