SimScale simulation projects by coxjared | Page 1

coxjared's profile

Tutorial project for a flow analysis of a pipe junction. The project only provides the geometry to start with. See our tutorials section to have a look at the step-by-step instructions to set up the simulation.

cooling analysis of a pcb for MAC Formula Electric

The tutorial project is a sample Electronic cooling sink which consists of 3 solid regions and 1 fluid region. The solid regions are two FB-4 chips, which have a higher initial temperature and a heat sink over one of the chips. The air flows over the solid regions to remove the heat from it.

analysis of the bare chassis with no aero attached

Testing the new rear wing -  with new foil geometry and endplates

Analyze how stresses are distributed throughout the wing

test on rear wing for forces on swan necks

In this tutorial, a aerodynamic analysis of a F1 frontwing is presented. The flow around the wing is modeled as an incompressible, turbulent flow using a k-epsilon turbulence model. This tutorial is based on the first part of the SimScale F1 Simulation workshop series about aerodynamics.

Sample project for how to set-up the Hex-Dominant Parametric mesh for flow around a vehicle body.

Tutorial project for a stress analysis of a connecting rod. The project only provides the geometry to start with. See our tutorials section to have a look at the step-by-step instructions to set up the simulation.

Public Profile

coxjared's profile