Subsonic

Find projects using the subsonic analysis type here. | Page 2

This tutorial project aims to showcase how to set up and run a simulation for a pump geometry. The Standard meshing tool was used.

CFD analysis for diff drone designs - Copy

In this project, a thermal shock & flow analysis of a globe valve is performed. Multiphase (Air/Water) & Single phase flow is modeled. - Copy

In response to 
https://www.cfd-online.com/Forums/main/248336-unexpected-velocity-profiles-pipe-flow-elbows.html

This project demonstrates the flow of liquid water flowing through a heat-exchanger. The purpose of this simulation is to analyse the flow distribution and check if there are air locks created.

This tutorial teaches how to run a transient incompressible flow simulation using the Multi-purpose analysis type in SimScale using the AMI rotating zone on a Francis turbine.

Validation of the performance of a centrifugal pump with the Subsonic analysis type, automatic pump curve generation and transient analysis.

This is a demonstration case for real gas feature

Transient analysis of external aerodynamics of quadcopter drone

3D Printed Centrifugal Pump, as seen on grabcad: https://grabcad.com/library/3d-printed-centrifugal-pump-1

Virtual Simulation of Centrifugal Pump Cavitation

Symmetric quadcopter flow and stress analysis - Copy

Tutorial project for a flow analysis of a pipe junction. The project only provides the geometry to start with. See our tutorials section to have a look at the step-by-step instructions to set up the simulation. - Copy

Cooling plate design of a hydrogen fuel cell - Copy

This tutorial project aims to showcase how to set up and run a simulation for a pump geometry. The subsonic meshing tool was used with coarse meshing. - Copy

Part of my thesis on cooling channel layouts

Subsonic multiphase project on oil filter from Jon

The results of this SimScale validation case of a centrifugal pump are compared with the results of the study by WANG Xiu-yong and WANG Can-xing entitled Performance Prediction of Centrifugal Pump Based on the Method of Numerical Simulation.

The SimScale Multi-purpose solver was used.

In this validation case, a Francis turbine is validated for total pressure drop, power and efficiency against TCAE and Hidroenergia.

This project simulates laminar flow through a straight circular pipe.

Cavitation investigation study of Centrifugal pump.

Subsonic | SimScale Project Library | Page 2