Multiphase

This analysis type is used to simulate the time-dependent behavior of fluid mixtures, for example air and water. The analysis is carried out using the VoF (Volume of Fluid) method which is a standard approach for the computation of multiphase systems. | Page 56

This simulation is to try and recreate the experimental results found in research articles to allow for easier manipulation and study

Tutorial project for a flow analysis of a pipe junction. The project only provides the geometry to start with. See our tutorials section to have a look at the step-by-step instructions to set up the simulation.

personal tutorial - multiphase fluid in pipe

Second test to check if changing AMI to MRF would allow the simulation to run successfully.

dispersed phase: water
continuous phase: air
DNS

Passive scalar transport for UVM CFD course Fall 2017

Examine shear layer formation and passive scalar properties of the flow.

create topless box by increase height of box.

test03 for simulating behaviour of liquid in spin coater.

Testing spin coating using different CAD diagram.

This project simulates the free movement of floating boat under a wave using 6 DOF motion.

Tutorial on simulating shear layers for ME 249

Wave breaker is simulated  in a water pool

VERIFY THE CAPACITY OF THE DRAINAGE DUCT OF A FORMING TABLE. 
IT IS PROPOSED TO USE A SIMULATION FALL OF WATER, UNDERSTANDING THE PROBLEM AS AN OPEN CHANNEL CASE.

Water filling of tank from incoming waves with safety openings for flushing out water

Multiphase | SimScale Project Library | Page 56