Frequency

The Frequency analysis type is used to calculate the natural frequencies of constrained or free parts and assemblies. Besides the numerical value of the eigenfrequencies, the results provide insights into the deformation behaviour of the corresponding eigenmodes. | Page 73

Frequencies of free vibrations of a 3-D stepped beam of smoothed geometry

The aim of this project is to simulate a trailer design, and see the loads acting on the leaf springs if the front tyre of the body goes through a bump on an uneven road while the body is already at the resonant frequency.

cfd of F1 front wing to understand the fluxes

CFD analysis of vertical turbine + Some FEA studies

Target: To find the maximum flow with minimum levels of vibration for the cross flow fan. This is a sample project to show the air flow for particular vibration experienced by the fan. Design changes needs to be made to narrow down to the best design

Test case of a modal analysis of a fully fixed plate.

Simple transport bracket stress analysis while lifting a heavy weight. Original project of @Duffman

Find  the modes and mode shaped of a big round Al plate

simscale DIY 3D printer workshop session 3 Homework

partitioned CAD model-3D printer assembly

3rd Homework assigned for the 3D Printer Workshop Series

Frecuency and Harmonic analysis of a 3D printer's frame.

working to test modal properties of a horn

In this project vibration analysis of jet engine is performed.

Frequency-Dynamic Analysis for crankshaft

With this project the impact of the mesh order and fineness on the eigenmodes of a simple beam is shown.

This project shows the frequency analysis of the truss bridge for first 20 eigenmodes.

Frequency | SimScale Project Library | Page 73