Frequency

The Frequency analysis type is used to calculate the natural frequencies of constrained or free parts and assemblies. Besides the numerical value of the eigenfrequencies, the results provide insights into the deformation behaviour of the corresponding eigenmodes. | Page 63

Frequency analysis and other test for structural requirement in consideration HSE OTO 2001/072 and CAP 437.

Evaluate strength in static and dynamic simulations

Tutorial for doing a modal analysis in Simscale.

Determine natural frequencies for fixture only

Acoustics simulation for Soprano 1/4 bridge length brace worm drive

to determine the first 5 natural frequencies and mode
shapes for the prestressed model airplane wing

Modal analysis of a TroyBilt two-stroke engine connecting rod.

The purpose of this project is to determine whether the stresses developing in the lift mechanism remain below yield strength. A 2:1 factor of safety is desired. If stress is too high, then the mechanism will need redesign.

To find out the natural frequencies of the components

Frequency | SimScale Project Library | Page 63