SimScale simulation projects by apinzon_tellez | Page 1

apinzon_tellez's profile

This tutorial aims to showcase how to set up a compressible analysis. An aircraft wing geometry is used.

Tutorial on incompressible flow simulation for aerodynamics studies, using SimScale Standard mesh algorighm.

This project aims to showcase the process of setting up and running an incompressible analysis. As a geometry, we have a Francis turbine. A MRF Rotating Zone is used for the runner.

This tutorial project aims to showcase how to set up and run a simulation for a pump geometry. The Standard meshing tool was used.

Tutorial project for a flow analysis of a pipe junction. The project only provides the geometry to start with. See our tutorials section to have a look at the step-by-step instructions to set up the simulation.

Tutorial project for a stress analysis of a connecting rod. The project only provides the geometry to start with. See our tutorials section to have a look at the step-by-step instructions to set up the simulation.

In this tutorial, the transport of exhaust gases into the atmosphere is simulated. Gases will come out of two chimneys of a plant.

This advanced thermal management tutorial describes the setup and analysis of electronics cooling on an electronics box containing different electronic components being cooled by the airflow of a fan.

Computation of the thermal comfort including Local Mean Age of Air and radiation in a meeting room using CFD simulation.

LED Spotlight project, aiming a bring the temperature of the diodes of a LED spotlight design below the maximum allowed temperature of 100C. A Conjugate Heat Transfer v2.0 analysis is used.

Conjugate heat transfer simulation tutorial.

Empty project containing the geometry of an engine piston for the thermomechanical tutorial of an engine piston

Thermal Analysis of a Differential Casing

Tutorial project for a thermal analysis of a differential casing. The project only provides the geometry to start with. See our tutorials section to have a look at the step-by-step instructions to set up the simulation.

Public Profile

apinzon_tellez's profile