SimScale simulation projects by andreas_fischer | Page 1

andreas_fischer's profile

FSAE workshop session 1-Front Wing Analysis homework tutorial project.
For Step-By-Step see: https://www.simscale.com/forum/t/step-by-step-tutorial-homework-of-session-1/52675

In this project vibration analysis of jet engine is performed.

FEA Master Class Session 3 handout: In this project the drop test of an iPhone 6 has been performed with and without case.

This project demonstrates the usage of rotating zones

This project contains resources for Session 1 of the F1 Workshop

streamwise webinar project for external aerodynamics of Ahmed Body and NACA wing section. The results from CFD were used for comparison with experimental data from ProCap software provided by streamwise.

The effect of numerics on the simulation quality and convergence time.

In this exercise, you will perform a simple heat transfer analysis on the SimScale Platform and then compare the results to a hand-calculated solution.

In this exercise, you will use linear static analysis to analyze several configurations of an aircraft engine bracket under a vertical load.

In this exercise, you will complete a laminar pipe flow analysis

This project simulates the air flow around the Ahmed body for validation purposes.

FEA in Formula Student & Formula SAE -   Exercise 2 Heat Transfer of a Cooling Plate

This project demonstrates the static stress analysis of three aircraft engine bearing bracket models considering both linear and nonlinear material definition. The models used in this analysis are taken from GrabCAD users who were the winners of GrabCAD 'Airplane Bearing Bracket Challenge'. The models are tested with horizontal and vertical loading conditions as provided on the challenge page of GrabCAD.

The project simulates 2 cases of aircraft wings to compare the aerodynamic effects.

Tutorial project for a flow analysis of a pipe junction. The project only provides the geometry to start with. See our tutorials section to have a look at the step-by-step instructions to set up the simulation.

Tutorial project for a stress analysis of a connecting rod. The project only provides the geometry to start with. See our tutorials section to have a look at the step-by-step instructions to set up the simulation.

FSAE-Workshop Session-3 Homework project for aerodynamics of full car

In this exercise, we will consider the deflection of a cantilever beam with a concentrated load at the free end. We can calculate the deflection by hand and via a static analysis using the SimScale platform.

Incompressible Fluid Flow analysis of two globe valves

FEA in Formula Student & Formula SAE - Upright FEA Simulation

FSAE-Workshop Session-2 Homework project for aerodynamics of complete Formula Student Race Car

Public Profile

andreas_fischer's profile