SimScale simulation projects by amorales_casas | Page 1

amorales_casas's profile

This simulation aims to simulate the static forces acting on a cutting tool insert and support under the following conditions.
 The final turning tool insert characteristics were:
ap 1.8 mm (0.3-4.2)
fn 0.19 mm/rev. (0.09-0.28)
C 225 m/min. (310-150)
The characteristics of the cutting tool shank:
Tool cutting edge angle: 75
Tool lead angle: 15
The cutting condition of the task was:
depth of cut (t) 2 mm
feed 0.2 mm/rev.
cutting speed 200 m/min
cutting material, C45 (DIN)
The forces acting on  the cutting area are:
Fx: -1436.5N
Fy: 1447.8N
Fz: -180.2N

In this project, a simplified cutting tool with insert is analysed.

Static simulation of a turning cutting tool using half section of a cutting insert.

Tutorial project for a stress analysis of a connecting rod. The project only provides the geometry to start with. See our tutorials section to have a look at the step-by-step instructions to set up the simulation.

Public Profile

amorales_casas's profile