SimScale simulation projects by akopp | Page 1

akopp's profile

This is the project corresponding to the third sessions of the FSAE Workshop organized by SimScale. It aims at analyzing the effect of Yaw on the aerodynamics of the full car.

Tutorial project for a flow analysis of a pipe junction. The project only provides the geometry to start with. See our tutorials section to have a look at the step-by-step instructions to set up the simulation.

This is the Front Wing of a FSAE car in a standard angle. This is part of the FSAE CFD Workshop organized by SimScale.
The aim is to analyse the flow of air and find drag, lift and flow separations.

Simulation of the car aerodynamics with a custom wing. The Design is pretty poor since I am no SolidWorks Expert. I was unable to merge properly the Custom Front Wing and the rest of the car. I had either a problem of scale or a problem of position. Solidworks seemed unable to save the Front Wing elsewhere than on the origin. Therefore, I did only a simulation of the Front Wing.

FSAE Full Car Simulation - Copied from user @mpoulter as I couldn't get the meshing to run without error.
Simulation has been reset then re-done by myself.

Public Profile

akopp's profile