SimScale simulation projects by Skanda | Page 1

Skanda's profile

Tutorial on incompressible flow simulation for aerodynamics studies, using SimScale Standard mesh algorighm.

Novacrypt Vulcan rocket nose cone cfd compressible flow

Empty project containing the geometry of an engine piston for the thermomechanical tutorial of an engine piston

Tutorial project for a stress analysis of a connecting rod. The project only provides the geometry to start with. See our tutorials section to have a look at the step-by-step instructions to set up the simulation.

Drone propeller flow analysis simulation using MRF model and SimScale standard mesher.

Aerodynamics of Cindy in Spongebob Squarepants

F1 Front Wing Geometry for Frontwing Tutorial

This project aims to showcase the different configuration options for the standard meshing tool, including basic and advanced settings. The various refinements are also covered.

It is the simulation of gas flow in a rocket engine nozzle

This tutorial aims to showcase how to set up a compressible analysis. An aircraft wing geometry is used.

Thermal Analysis of a Differential Casing

This projects aims to showcase the function of a golf ball's dimples, compared to a same ball of smooth surface.

Tutorial project for linear static analysis of a crane

A basic project on simulating the flow of water in a water turbine

This tutorial project aims to showcase how to set up and run a simulation for a pump geometry. The Standard meshing tool was used.

LED Spotlight project, aiming a bring the temperature of the diodes of a LED spotlight design below the maximum allowed temperature of 100C. A Conjugate Heat Transfer v2.0 analysis is used.

Public Profile

Skanda's profile