SimScale simulation projects by Ricardopg | Page 1

Ricardopg's profile

Trough with a weir to check for even water levels over length of weir

This project simulates the response of a paving stone subjected to harmonic pressure.

This project aims to showcase the use of vortex generators (VGs) in an incompressible flow inside a pipe.

Tutorial project for setting up the Automated Hex-dominant for internal flow for an angled pipe geometry.

Tutorial on incompressible flow simulation for aerodynamics studies, using SimScale Standard mesh algorighm.

This project aims to showcase the different configuration options for the standard meshing tool, including basic and advanced settings. The various refinements are also covered.

IA crash test tutorial for a dynamic simulation of an FSAE Impact Attenuator.

F1 Front Wing Geometry for Frontwing Tutorial

Empty project containing the geometry of an engine piston for the thermomechanical tutorial of an engine piston

This project shows the bending of an Aluminium pipe through rolling process.

This advanced thermal management tutorial describes the setup and analysis of electronics cooling on an electronics box containing different electronic components being cooled by the airflow of a fan.

LED Spotlight project, aiming a bring the temperature of the diodes of a LED spotlight design below the maximum allowed temperature of 100C. A Conjugate Heat Transfer v2.0 analysis is used.

Tutorial project for linear static analysis of a crane

In this tutorial, the transport of exhaust gases into the atmosphere is simulated. Gases will come out of two chimneys of a plant.

This projects aims to showcase the function of a golf ball's dimples, compared to a same ball of smooth surface.

This tutorial aims to showcase how to set up a compressible analysis. An aircraft wing geometry is used.

Study of CO contamination inside a car park

Drone propeller flow analysis simulation using MRF model and SimScale standard mesher.

Conjugate heat transfer simulation tutorial.

This project simulates the airflow around an approximative model of the newly announced Tesla Cybertruck. Geometry from https://www.simscale.com/forum/t/tesla-cybertruck-aerodynamics-simulation-project-by-mesfahani/86997

Tutorial project for a flow analysis of a pipe junction. The project only provides the geometry to start with. See our tutorials section to have a look at the step-by-step instructions to set up the simulation.

This project aims to show, with simple setup/geometry, how to use different T1 units and convert them back to ppm using Paraview.

This meshing tutorial shows how to setup the Tetrahedral automatic, Tetrahedral parametric and the Tetrahedral with local refinements for a structural analysis simulation.




Gas water heaters are commonly used in houses as an a substitute to electric resistance heating. As a result of the process, some hazardous gases are produced, including CO. Normally these gases are taken straight to the outside through a chimney.
Problems with this chimney could result in a deadly atmosphere. This project will explore this scenario using passive scalar transport.

In this project a static analysis of a shaft subjected to a user defined rotation and a cyclic boundary condition is demonstrated. The objective is to evaluate a shaft consisted of a single part against a shaft split in half.

In this project a transient thermo-structural analysis of a spherical pressure vessel is demonstrated.

In this project vibration analysis of jet engine is performed.

Predict the resistance (the total and later split this in their components) in calm water using a single phase, steady-state, incompressible, isothermal and viscous flow, with the use of wall functions and a turbulance model.

Tutorial project with the goal of simulating the wave effects on a boat.

Public Profile

Ricardopg's profile