SimScale simulation projects by OopsClunkThud | Page 1

OopsClunkThud's profile

This simulation is to try and match the mass flow ratio in the 3D to the exhaust port flow modeled in EngMod 2T.

measure mass flow rate of stock carb and addition of bell

Analysis of the transfer port flow direction

Sharp Edged exhaust port into a large exhaust to study the flow direction with no wall influence.

Verification model of compressible flow for pressure ratios up to 8

Looking at side wall angle from radial (0*) to straight (44*) all with a 10*down angle.

measure change in mass flow rate as side wall angle is changed from straight to radial

test impact of port side wall angle and roof/piston radius on flow volume

Public Profile