SimScale simulation projects by Leo_Zhang | Page 1

Leo_Zhang's profile

Create simulation of horizontal launch of X-33 spaceplane. Use properties and initial conditions from models of 737 airliner and swept wing public projects. - Copy

Goal is to accurately determine the lift to drag ratio when the vehicle takes off horizontally. New Creo 5.0 solid model with large fillets at the root of winglet plus fillets on fudder and all with rounded airfoil tips. Simulating with compressible flow using aerodynamic constants from Airflow around a Commercial Aircraft project. - Copy

Show flow in and out of Model to be 3D Printed - Copy

CFD Simulation of an F16 fighter jet. - Copy

Primary objective is to determine the vortex lift effect above the Concorde's delta wing
CAD provided by 'Aisak' here,  https://grabcad.com/library/proyect-concorde-unfinished-1 - Copy

An experiment to visually demonstrate the difference in lift generation between delta and straight wings, and why the delta wing has a more steady stall. - Copy

This project involves a static structural simulation of an aircraft wing which is subjected to bending and torsional load due to wind pressure. - Copy

A wind simulation of a building cluster as a side project - Copy

EuroAVIA-Workshop Session3 -Aerodynamics of an Aircraft. This project simulates air flow around an Aircraft at low sub-sonic compressible flow regime. - Copy

This project simulates a water purification process in a maze channel reactor. - Copy

This project involves meshing externally a Boeing 777-200 LR Aircraft, and then simulating its' operation on flight facing an airflow with an axial velocity of 50 m/s.  It is one of the longest-range commercial airliners, with an exterior length and wingspan reaching 63.70 and 64.80 meters respectively.  For this case a model with removed engines was chosen in order to assist convergence and meshing. Also a Symmetry plane was added midst the Part, and half the part was used for meshing and simulation for simplification.  A steady state compressible flow simulation is executed to visualize the air flow around the bodywork and wings of the aircraft, as well as the pressure distribution while on flight. - Copy

This project simulates transient wake formation behind a boat. - Copy

Propeller_3.11.06-PropellerModel - Copy - Copy

Analysis of an internal flow in the engine compartment - Copy

Apollo Reentry Vehicle, not compressible (sad...) - Copy

Test of compressible flow around an object. In this case, a space Shuttle - Copy - Copy

Orbiter Simulation is done and various data is gathered. - Copy

Wind Tunnel Airfoil experiment - Copy - Copy

Determine the drag coeff of the rocket - Copy

This tutorial aims to showcase how to set up a compressible analysis. An aircraft wing geometry is used. - Copy

External aerodynamics on a vehicle
No rotating wall for wheels - Copy - Copy

Retro-inspired supercar aerodynamics - Copy

Tutorial on incompressible flow simulation for aerodynamics studies, using SimScale Standard mesh algorighm.

Winglet CFD for THERMOFISHER Science Fair

Tutorial project for a flow analysis of a pipe junction. The project only provides the geometry to start with. See our tutorials section to have a look at the step-by-step instructions to set up the simulation.

Public Profile

Leo_Zhang's profile