SimScale simulation projects by Flavius | Page 1

Flavius's profile

Homework Submission

 Full car model FSAE Full Car with a radiator using the porous media approach7, rotating wheels using the rotating wheel boundary condition3, and rotation of the car rims using Multi Reference Frame (MRF)3. For this case, the front wing flap angle of 0 degrees will be considered and the velocity of the car will be set at a constant 20 m/s.

FSAE workshop session 1-Front Wing Analysis homework tutorial project.
For Step-By-Step see: 
1. https://www.simscale.com/forum/t/step-by-step-tutorial-session-1-front-wing-design-study-part-1/78755
2. Tutorial part 2: https://www.simscale.com/forum/t/step-by-step-tutorial-session-1-front-wing-design-study-part-2/79155

investigate the full car running in a straight line at 20 m/s with side wind. You will have the same model we used for the last session, so you will setup porous media, MRF (rotating) zones, rotating walls, and the flap angle will be 0 degrees. Think about how this setup differs from the previous one and think about the impact of the side wind on the performance of the car and the flow behavior around it.

Design and test your own FW design compared with the one from previous sessions.

Tutorial project for a flow analysis of a pipe junction. The project only provides the geometry to start with. See our tutorials section to have a look at the step-by-step instructions to set up the simulation.

Public Profile

Flavius's profile