SimScale simulation projects by Dhaval | Page 1

Dhaval's profile

In this exercise, you will complete a laminar pipe flow analysis

In this exercise, you will perform a simple heat transfer analysis on the SimScale Platform and then compare the results to a hand-calculated solution.

In here as a part of a course taught by Anna Flessner, I am attempting to figure out the Aerodynamic Performance of 2 Propellers.

In this exercise, you will use linear static analysis to analyze several configurations of an aircraft engine bracket under a vertical load.

In this as a part of a homework I will attempt to find out the stresses when the wing is applied a bending and torsional load as part of a wing pressure phenomena.

Tutorial project for a thermal analysis of a differential casing. The project only provides the geometry to start with. See our tutorials section to have a look at the step-by-step instructions to set up the simulation.

Incompressible Fluid Flow analysis of two globe valves

FEA Master Class Session 3 handout: In this project the drop test of an iPhone 6 has been performed with and without case.

Tutorial project for a flow analysis of a pipe junction. The project only provides the geometry to start with. See our tutorials section to have a look at the step-by-step instructions to set up the simulation.

FSAE workshop session 1-Front Wing Analysis homework tutorial project.
For Step-By-Step see: https://www.simscale.com/forum/t/step-by-step-tutorial-homework-of-session-1/52675

In this exercise, we will consider the deflection of a cantilever beam with a concentrated load at the free end. We can calculate the deflection by hand and via a static analysis using the SimScale platform.

Tutorial project for a stress analysis of a connecting rod. The project only provides the geometry to start with. See our tutorials section to have a look at the step-by-step instructions to set up the simulation.

FSAE-Workshop Session-2 Homework project for aerodynamics of complete Formula Student Race Car

Heat Exchanger performance is integral to the enhancement of energy efficiency. Typical heat exchangers are equipped with parallel flow and/or counter-flow arrangements. Two fluids flowing in parallel or in opposite direction to each other serve as heat sinks or sources as the requirement may be. This study considers a novel consideration for a heat exchanger, wherein, the heat exchanger consists of tube with a narrow slot oriented in the stream-wise direction. This study is aimed at validating the novel design against experimental hence providing a proof-of-concept.

This is the homework for the Workshop and I wish to submit it to the SimScale team and to learn the procedure of Simulation.

FSAE-Workshop Session-3 Homework project for aerodynamics of full car

This project demonstrates the static stress analysis of three aircraft engine bearing bracket models considering both linear and nonlinear material definition. The models used in this analysis are taken from GrabCAD users who were the winners of GrabCAD 'Airplane Bearing Bracket Challenge'. The models are tested with horizontal and vertical loading conditions as provided on the challenge page of GrabCAD.

Public Profile

Dhaval's profile