SimScale simulation projects by 210301161094 | Page 1

210301161094's profile

simulate stress and deformation in a wing panel at high speed

A threaded joint is subjected to a tensile load of 5000 N with a temperature of 100 C. The outer surfaces of the treaded joint are applied with convection of 20 W/m2-K, while keeping the other end fixed. Determine the von mises stresses along with the temperature distribution along this threaded joint.

Determine the temperature and heat flux distribution over an exhaust pipe made up of aluminium alloy whose inner surfaces are exposed to hot flue gases with a temperature of 2000 C; while the outer surfaces are subjected to a convective film heat transfer coefficient of 20 W/m2

Determine the von mises stress and displacement for a bridge and state whether it is capable of carrying load of 100 persons at a time considering 100 kg for each person.

Determine the temperature and heat flux distribution over a piston block made up of aluminium alloy whose top surface which is exposed to combustion is subjected to a temperature of 2000 C; while the bottom hollow end is subjected to a convective film heat transfer coefficient of 20 W/m2-K.

Determine the temperature and heat flux distribution over a heat sink made up of aluminium alloy whose base is attached on the cpu which is releasing heat flux at the rate of 2000 W/m2. In order to cool it a cooler booster fan blows air for which convective film heat transfer coefficient of 20 W/m2-K is maintained.

An oldham's coupling of aluminium alloy is subjected to a tensile compressive and transverse load of 500N separetely in three different cases

a knuckle joint of  aluminium  alloy is subjected to a tensile, compressive and transverse load of  5000N separetely in three different cases

determine the von mises stress and displacement contours

Public Profile

210301161094's profile